How to Shield Your Walk-In Cage with the Right Cover

Quick answer

Choose a UV-stabilised, weather-resistant cover that fits your specific cage dimensions, then secure it properly to prevent flapping and water pooling.

Step-by-step: fitting your walk-in cage cover

1. Measure before you buy: Measure the length, width, and height of your cage frame at the attachment points. Add a few inches allowance for slack—covers that are too tight may tear in wind, while overly loose ones will pool rain.
2. Position the cover evenly: Drape the cover over the cage so the seams align with the frame edges. Avoid stretching it diagonally; a skewed fit leaves gaps at corners. Common mistake: pulling the cover too taut on one side, which causes the opposite side to lift.
3. Secure all anchor points: Use bungee cords, ratchet straps, or integrated ties at every designated loop. Fasten at least two points per side. Leave a slight droop in the centre so water runs off instead of collecting. Check anchors after the first rain or gust—fabric stretches slightly once wet and may need re-tensioning.
4. Add a section cover for flexible shade: If you have an extra cover for walk in cage, attach it over a single section using the same method. Position it on the side that gets the most afternoon sun or prevailing wind.

Product that makes the job easier

• Extra Cover For Walk In Cage: This optional cover piece is made from the same UV-stabilised, weather-resistant polyester as the main roof cover, designed to fit neatly over one section of your walk-in cage. Adding a section cover creates a shaded refuge without covering the entire enclosure, giving your animals freedom to move in or out of protection.